miniZ v1.3n+ is out!

Hi everyone, thank you for your support and your precious feedback!

There is a miniZ version v1.3n+ for you to download.

  • Reduced CPU usage to background levels.
  • Better invalid share detection.
  • Ignore pers auto for 150,5.
  • Fixing issues with worker going offline.

On Download page you can find Cuda 10 and Cuda 8 versions (Linux and Windows).

If you have RTX GPUs then you need to use Cuda 10.0 versions. However, for other GPUs performance may depend on the driver you have installed. So, you need to test and see which performs best.

Download miniZ version v1.3n+ here!

* It is advisable to always download from miniZ website, and to always verify the checksum. *

Engage, feedback and support

For additional information check our Usage or FAQ pages.

Because your feedback is precious, miniZ kindly encourages you to use the comment box below for general questions and feedback.

Certainly we will strive to help you with any doubt and provide a solution to any problem you may encounter. In case you need to reach us, please check the Support page.

Follow us
On Twitter
Our thread on bitcointalk.org

Finally, miniZ wishes you a fast and friendly mining experience!

Categories

Comments

  1. Yossi1114 says:

    I get the following error after running a few seconds:

    CUDA error ‘cannot set while device is active in this process’ in func ‘eq_<e[B<2

    https://i.imgur.com/WBekxZM.png

    GTX 1080 x8
    CUDA 10.1

    • miniZ says:

      Hi Yossi1114,
      Thanks for reporting your problem.
      We cannot reproduce the issue, but we might have fixed it a few minutes ago.
      could you please download and try miniZ again?
      Please check the build that to be sure that you have the correct version
      C:\Users\miniZ>miniZ --version
      ************ miniZ v1.3n+ ************
      miniZ v1.3n+ @ cuda v10.0, Apr 27 2019 16:30:31

      Cheers,
      miniZ

      • Yossi1114 says:

        Thank you for fixing the error, there is no error anymore!
        I also changed the CUDA version to 10 from 10.1. Hope this helps.

        Anyway, it is working correctly! Thanks a lot.

    Leave a Reply

    Your email address will not be published. Required fields are marked *